Cyberdata IP Notification - SIP RGB Strobe (Indoor)

When installed, the wall-mounted SIP RGB Strobe works as a visual alarm device. The device can be set up as part of a ring group (call group), with the strobe activated as a notification of incoming calls. The SIP RGB Strobe can also be activated by being part of a multicast group. When audio is detected on a specific multicast address and port, the strobe is activated.
Through a web page setup, you can make the SIP Strobe respond to message waiting signals by flashing. When the message has been heard, the strobe stops flashing.

Multiple colours, flashing rate and brightness can be selected for each of the different activation methods. Users can also use CyberData’s HTTP command set to directly access the strobe functions.

Note: Support of SIP RGB Strobe with Syn-Apps devices via multicast mode.

• Meets ADA requirements for telephony signalling and notification
• Multiple colours, blink rate and brightness can be selected for each of the different activation methods
• Programme or listen to up to 10 multicast addresses
• SIP activation
• Mailbox Message Waiting Indication
• Multicast activation
• Cisco SRST support
• Event-controlled relay
• Tamper sensor
• Web-based setup
• PoE-powered